so I was rolling endos the other day, and my bike was vibrating fkn bad!!!
took a lat. runout on my front rotors today...0.030"(spec = 0.008" max)
any ideas on how this might have happened???(besides heat)
holla

 

front wheel bent??

 

front wheel = less than 0.001"

 

the rivets might be loose

with a regular hammer and a ball pean hammer and some carefull swings you might be able to tighten them up but used rotors are cheap

 

didnt check that...if im spending and more $$$ on this front im gettin a 600rr('05)...might as well at this point. rode my boyz f4i w/954 front = pimp...and mana's f4i w/1000rr front = pimp. and i can get a cheap rolling 600rr front.

 

i just put an 06 rr front end on my boys 03..

it's nice but could use some thicker oil

 

was it easy???(r&r)

 

direct fit but i didn't mention the 03 was an rr also

 

How about a bent rotor? I don't think you would have damaged the wheel. You could also try to loosen the screws that connect the rotors to the wheel and then retighten them. Good luck.

 

whell 0.030" of LRO is def a bent rotor...I want to know what might have
caused this and is it common on the f4i

 

those cheap bike chock thingies

 

haha guess thats why the brake cleaner wasn't doing **** for ya.

 

haha...yup