Any have a picture of Scrape bar on SRAD?
04-24-2003, 04:10 PM
#1
florida! finally
Thread Starter
Join Date: Dec 2002
Location: clearwater fl
Age: 42
Posts: 4,882
Any have a picture of Scrape bar on SRAD?
I am buiding a bar for my 99 gsxr......just wondering if anyone has some pics or tips for me......i remeber someone saying that its good to reinforce the subframe.
thanks,
Nate
thanks,
Nate
04-24-2003, 04:50 PM
#2
dedrater
Join Date: Oct 2002
Location: Lewiston, Me
Posts: 9,815
Run 1x1 angle steel around the inside of the trunk underneath the top sets of tube.
Weld the 1x1 box together (youll have to cut a notch out of the 1x1 to make room for the latch). weld your support bars for the scrape plate to the 1x1 angle, drill your holes through the subframe and plates.
Hope it helps,
Ill try and get pics for you if I can
Weld the 1x1 box together (youll have to cut a notch out of the 1x1 to make room for the latch). weld your support bars for the scrape plate to the 1x1 angle, drill your holes through the subframe and plates.
Hope it helps,
Ill try and get pics for you if I can
04-25-2003, 07:47 AM
#5
dedrater
Join Date: Oct 2002
Location: Lewiston, Me
Posts: 9,815
Nope
Originally posted by Nate-CBR
do you have to get rid of your trunk?
do you have to get rid of your trunk?
No the 1x1 channel actually runs around the tubing for your trunk. You run the support plates for the scrape plate on the outside of the trunk and cut your plastic. Trunk stays intact. I tried to get pics but the guy with the camera wasn't around last night.
Thread
Thread Starter
Forum
Replies
Last Post
