Does anyone have any pics or ideas of what to use to cover the air ducts when I take off the fairings?
I was thinking of using that cheap grill stuff you can get at autozone. How would I install that?

 

why...just run them open

 

I was thinking about that but just checking out options too

 

yeah, I think just about everyone takes those air ducts off...

 

I think I remember reading that F4i its best to close one from inside. Anyone know of anything like this for the R6?

 

epoxie puddy or a plastic welder is the best bet, depends on what sort of mesh you are installing. I'v even seen some JB weld hold the mesh thing under fairings.

 

i use duct tape on mine....but just do one not both

 

Whats the point of blocking one off?

 

duct tape.. but i think its a urban myth.. mine is only taped cuz it came like that..

 

run em open, never had a prob

 

ive never had a problem.. i run them open

 

 

i don't know but this isn't stunt discussion.

 

blocking one air duct can cause a slight increase in air velocity. if you were to do that one duct has to **** twice the air in the same time to keep the engine alive, increasing velocity. but once it hits the air filter all effects are canceled. so... decide for your self.

 

Yeah but no one answered the Bearing question I submitted.
Hows that handbrake working?

 

my old f4i I took them out and there was a noticeable loss of lowend power, so on my new one I just trimed them

 

I found the thread
it was do to powerloss
Trimming them down looks like a good idea.