I just got through bolting up my new 750 engine in my 01 600 frame. I still have alot of work to do as you can see from the pics but I should be done by midnight.

You can see the front motor mount bolts (where the frame sliders go) done bolt up. The two mounts in the back and the third mount on the front left side bolt up fine. I am going to take it to a machine shop downtown tomorrow to get the engine mounts adjusted.

 

2

 

3

 

4

 

The holes are only off enough to **** me off cause I cant stick a bolt through them. I am thinkin it should be easy for the dudes at the machine shop to fix it.

 

nice work man. I thought the 750 motors droped right into those?? oh well, alittle fabrication & bam. instant power!

 

Thanks.. Suzuki had to be a bitch and make each engine a little different but its all good cause I just found out that there is a company that makes brackets for the 750s that will allow gixxer 1000 motors to be installed into the 750 frame. After the thing gets back from the shop, it will basically be a 750 frame so I should be able to switch between a g1k and 750.. w0ot!

http://www.gixxer.com/ubbthreads/sho...c=1&PHPSESSID=

^^thread on whats going on^^

 

Its welded up and bolted in. Check the above link for pics!

 

gixxer 1000 motor in a 600 frame would be mint. ultimate sleeper.