where you buy your rear master?

 

just read the thread again and look at the pics,i explained it already,the rear break setup includes the rear master

http://www.pccmotor.com/rear-brake-a...rf50-5012.html

 

No the left hand master!

 

i used 1 that i had,i had an old yzf600 i wasnt using so i used the front brake hand master from that ,i flipped it upside down put it on the left side under the clutch and ran a line off it. if u search some salvage yards you can find a handmaster that has a seperate rez w a hose .that way you can run it either way as long as the bottles above the rest of it. it was an 04 yzf600 ,that front break will work tit

 

here's a setup made for the big pocket bikes, 10" rims I got one on mine. It's pretty long.

http://fancyscooters.com/item00761-s...F001-rear.html

 

no **** .thats pretty cool what did u do for a mounting bracket

 

well it came stock on my bike cause the stock engine was a semi auto, no clutch but still could switch gears. It comes with a bracket already, but you could always mount one up with sheet metal and a lil welding and paint good 2 go!

 

heres my handmaster.i run a line off that down to the adapter shown next to it.it plugs right into the rear master cylinder and lets u have both

 

that handmaster new would cost alot but im glad i had it ,the breakline cost like 30 bucks and the adapter was 65 i think...pimp setup for a pitbike

 

DO IT UP GUYS! i got a whole entire swingarm with a 10" disc rear wheel and breakline thatl reach the bars and a handmaster that im not using.itll fit onto the crf50/xr50 prfect. the only reason im not using it is cuz my stock drum break w a 50stunt cable & brake arm works just as good.props to ryan for a kickass product.the brakes are a department you dont wanna slack and his parts are 100% reliable to save your *** when set up properly

 

this will work mint,just custom make a bracket,or use the stock caliper