Here it is ext. cab s10

350 with t350 trans
373 open rear end
15 inch prime wheels
edlebrock exhaust
2 inch drop in rear

now on to the extras!

everything for a 383 except for the block
-edlebrock intake
-ported/polished cast heads
-pistons
-rods
-timing chain
-400 crank ground to 350 mains
-Moroso valve covers
-new in box edlebrock carb 600
-cam(can't remember all the specs on it)

700r4 trans w/torq converter only about 1000 miles on it
Rear end with limited slip
16 inch prime wheels with 245 tires all the way around
2 inch drop leaf springs
3 inch drop blocks
new shocks and drop springs for front
extra radiator
newer style core support for syclone grill included
New headlights still in Box
Euro tail lights
Newer style interior(just needs to be installed)
new outer tie rod sleeves and ends
upper and lower balljoints
Roll pan

here are the problems
-drivers side rocker panel is rusted, needs a new one
-drivers side rear corner of cab is rusted, needs to be replaced
-starting to rust on bottom of drivers door
(those parts are only about 15 bucks each, I just don't have the time to weld them on)
-master cylinder just went out, will need a new one
-truck does not run( it only needs the new carb put on, and the new plug wires put on, and it will run.
-the floor of the bed has a few dents, but nothing you'll notice with the cover on it.

I don't have the time or space to finish this truck anymore.

I'm asking 1800 for it all and every single part I have for it. Or make me an offer, I just want it gone ASAP!

email me with questions slcpunk21@hotmail.com
I'm just outside of chicago

I'm also sure there are other parts I have forgotten to add to this. And here's a pic of it http://www.sportmachines.com/events/glg2001/098.jpg
I can also get you tons more pics of it and the parts just ask. Thanks!