any1 got any smooth techniques to putting new grips on and keepin them from spinning?

 

The easiest way to put grips on is used the air gun and blow air into the small hole and it slides right on...or soapy water just make sure it drys prior to riding Now as far as securing the grips you have several choices 1. grip glue (which is messy as hell) 2. use small metal wire.. (loop it around your grip) 3. Ziptie.. (also wrap it around your grip).. im sure there are a buch of other ways but these are the ones i tried...

 

grip glue or electrical tape wrapped around the handle bar

 

Hairspray.

 

Spit and safety wire. Honestly now.

 

my friend was telling me 2 saftey wire them but i can't find any wire thin enuf that don't tear my hands up, i don't like wearing gloves alot of times. whered u get the wire from?

 

little bit of soapy water and slide them on and let them sit
for a couple Hrs. and Vualla..

 

aqua net hair spray, when it dries its like glue. if you still have problems with them spinning your holding on too tight and you most likely also suffer from severe arm pump.

 

No gloves?!? other than your feet what the hell do you think is gonna hit the ground first. Hope you like not riding because you got rash on your hands.. haha. For me. Ill start my bike up and keep riding while your asking people for tweazers and peroxide is.

 

I always spray a little clear spray paint into the grip, then it slides right on, let it dry overnight and your good to go.

i guess you could use any spray paint, it doesn't have to be clear!