How do you remove the FRONT PEGS on a 2001 R6. It looks like you have to drill the piece out but not sure and really dont want to.

 

havent done it but u prolly just unbolt the rear set and then unbolt it from there?

 

well on a gsxr 600 you unsrew the bracket that holds the whole peg and branke or shifter. Then there is a bolt that runs through a hole and screws into the peg. Mine was an allen wrench. Tough as hella to get it unscrewed because there was thread-lock on the bolt. May be simular to urs. I highly doubt that any drilling is needed to remove a part off any bike. Especially something like a peg.

 

its a big allen bolt put the rearset in a vice and unscrew it

 

I was too lazy to remove the rearsets so I just dremmled the end of the pin that goes thru the peg and replaced it with a grade 8 bolt/nut and I was 'golden' took 15 minutes. dremmle the round end like you're cutting a pizza and use a screw driver to just pry it off.


l8r

 

yeah the rear ones are a big allen bolt. I am leaving those one. The front ones look like some bolt of some sort that I may have to dremel. The pegs I bought come with a Allen bolt to put back in. But the instructions that they come in say some bikes you have to drill out the factory peg. Thats crazy man...

 

So you dremmled it from the bottom?

 

you should get an idea from this pic...sorry about the angle