replaced clutch fiber plates....... adjusted the top and bottom bout five times..... its ridable, but anytime I go to do a wheelie or whack the throttle it slips like hell... any ideas?? the spacer plates look ok, just a little blue on two of them. thanks

 

were the steel plates warped? If they were, that could be causing the problem. Also did you soak the clutches in oil prior to installing them? Just thought i'd ask.

 

1. Is there any play in the clutch cable? There should be a little bit, it shouldnt be tight.

2. By any chance, did you just switch to synthetic oil?

 

Maybe you need to adjust your clutch springs or replace them. I dont know much about yamahas, but sounds like its a spring issue to me...

 

Soaked them in oil, check. Regular oil. New plates and springs, check. New master clutch piece, check. I'm the biggest retard ever, I didn't get the pressure plate on right, that was my problem. Thanx for your advice though. , sorry

 

No Prob...

 

I'm going to replace my clutch next weekend. Any more pointers? I didn't know you had to soak them. Thanks!

 

If you are going to run the same metal plates make sure you reinstall them the exact way you took them off, or just make sure they will be spinning in the same direction that they were...