Well I just went out and banged on my tank some with a rubber mallet. Looks very nice. I have been having a problem holding on when I do the high chairs and had a little dent in and some grip tape on it. Now I have a large dent just before the gas cap. The metal wrinkled some and the paint cracked in 2 spots but it isnt much of a deal to me. I might just end up finding some nice Krylon and going back over it so now the big dent will cup my *** alot more but I have seen people sit pretty far back, like on top of the gas cap at the back of the tank. Can I get some pro's and con's on how I should start practicing them again. Last time I tried I nearly slipped off.


Sit towards the front in the dent or further back???

 

im pretty sure it depends on how long your arms are.

just sit wherever you happen to be with your arms locked on the clip-ons.

 

vel cro

 

id use surfboard grip ......... even though all im using right now is a dented tank when doing higher endos i make sure im up front of the gas cap.... but for the wheelies it dont seem to matter.

 

got to sit back on your tail bone, not your *** cheeks. then you wont slide, hell i coated my tank with rhino liner, you know, the roll on **** for truck beds....

 

lol how is that rhino liner working for yah??? does it rip your pants or anything??? i know when i used skateboard grips it would rip my pants.....
surfboard grip seems to be the best for me though... here it is on my gsxr


and my f4i i dont really see the use for it..... but i know i couldnt do any highchair tricks when the tank was in good condition....... felt really unconfertable..... once its dented its all good

 

i did that to my gsxr too. but i did the tail too. and no it doesnt mess up your pants.

 

the rhino liner is great, doesnt fu(k up your pants, and you can still move around on it. not like grip tape, i tried that. with grip tape its hard as hell to rool back onto your tail bone and get a decent spreader.