i jumpered the wires to read the codes, fi light flashed 9 times. what code would that be??

 

Im not sure. But me and you have the same problem no spark and . I cant even get my bime to read self diagnostic codes

 

You might hVe to reset tge ecm by pulling out the jumper wire right after it blinks nine time it should blink for 5 seconds within the five seconds you must re enter the jumper wire. To reset the stored codes on the ecm. After that try an read the codes again. If its the same.. then check for what that code refers to. I think its loose or faulty conn. At the iat sensor or open circuit in the iat sensor