So I need some help adjusting my clutch cable.So I don't really think my clutch is going bad,but my problem is I run a e z pull clutch perch and I can pretty much pull the lever half way before it starts to pull the cable.I've tried adjusting the screw thing that runs into the clutch lever. I think I need to adjust the cable near my clutch case.whenever I pull the clutch in it isn't fully engaging so my bike will actually start moving whenever I put it in gear and is hard to put back in neutral. Any tips would be helpful.I think I have to make the cable tighter done near the clutch case if I need to take pics of what ever it called im trying think of I can. Thanks

 

it adjusts just like the screw on the lever.. should have 1 or 2 lock nuts and a long threaded boltish looking thing at the end of your cable... i loosen the nuts pull on the cable with my hand and screw that bolt lookin thing out untili can't turn it by hand anymore then tighten the lock nuts back.. r6 might be alittle different but same concept.. make sure you put the screw on the clutch lever all the way before you start

 

So turn the screw on the lever all the way in or just make sure its in. Pull the cable out towards the back of the bike or forward then tighten the nuts?

 

yea you got it man

 

I HAD THE SAME PROBLEM

u have an ez pull?
what i did was tighten the thing on the ez pull all the way in...then i backed it out a little

then while holding the line in that position i adjusted the line from the cluth arm on the side of the bike...

by the way i got a circle the other day...lol and high sided the next hahahaha

 

Thanks she's all set now.perfect it only took 3mins to fix.

 

Good ****.

 

good deal glad 2 see you got it working

 

so.. wheres my rep at bitches?? lol

 

at least your going to be famous soon. my rep meter say dont know about him