So clutch went out on my F4I so I replaced that last night along with putting MSR raptor on.

Well today I threw oil in it, changed oil filter and went to crank it up but it wont start

Do I have to cross the two wires together that pluged into the stock clutch perch? Or could it be something else?

Oh yes, turns on primes and turnsover but just wont start running

 

I do believe those 2 wires need to be connected, jump em and see if it starts, if it does cut and splice

 

Ok thanks man ill try that

 

i dont have my two wires connected and my bike runs?

 

Well that didnt work !@@#$$%% checked all fuses they are all good. I have no idea what it could be, I didnt **** with anything but the clutch .... any other opinions?

 

+1, without that wire, my bike did NOT start.

if you're sure you connected it, it cranks, you hear the pump prime and it STILL does not fire, check your coil wires.

p.s. make sure you install the plates correctly, on the f4i, there are not one, but TWO special fiber plates...cost me $200 to find out. good luck.