DSC

first off i know there is a thread where this was talked about, however i can't find it. i looked with google, and look at ton's of pages with no luck, so im gonna ask again. my front end shutters when doing endo's, and its very bad. it used to do it rarely but i thought it was from a warped rotor.
so i have replaced pads and rotor's, and now its ten times worse and more frequent. i have check and cleaned calipers to make sure they didn't stick, and they function fine. the only thing left would be wheel bearings and stem bearings. anybody ever figured this out and fixed it?

thanks drew

DSC

and its not head shake/tank slap its a front to back kinda movement rather than side to side

CHADf

i get the same **** when i have a shitty front tire!!!!

eazenutz33

shitty front tire would do it.......look at it and check for cupping, looks like the tread wears on the front edge, but not on the back edge of each tread. Comes from running improper pressure or never riding on anything but the center of the tire.

Other things that can do that are bad wheel bearings, bad stem bearings, and loose stem bearings. You could spend around $100 and put all those bearings in new, which isn't a bad maintenance thing to do anyways. Then get yourself a new front tire. If it stills does it, you should give me your bike! haha

DSC

tire is fairly new prob few months old with not man hours. and i am gonna do all the bearings when i get the money. it does it worse when cold gets a little better when hot

DSC

pilot powers all around

E-Loc540

you can check all your bearings rather easily.................? and you dont have to be mechanically inclined to do so.......