putting one on my 954. there are two wires coming from each bulb from the headlight. Just need to know which part of the harness I need to hook those wires up to. And can it be hooked up to a toggle switch so I have the option to turn them off if I'm hitting a lot? enlighten me o'great ones

 

yes u can have it on a switch.

ur setup would then have to be

bulbs TO switch TO harness

1 of both those 2 are grounds.

meaning u have 2 ground wires which you DIRECTLY connect to the ground wire on the harness (no switch in the middle)...

the other 2 wires, connect em to each other and then to the switch, from the switch, run another wire into ur low or high beam wire

...don't know wats wat on a 954....i can help u out if the harness is like a f4i, but i doubt that it is.

just start connecting **** together to see wat works. don't be afraid to blow a couple fuses.

EDIT:

wait, do u have ur left hand controls?

 

yes I have the hand controls

 

ground = frame/bolt etc anything metal on your bike is a negitive power source...

 

+1...ur radiator counts too.....id hook it up to the ground coming thru the harness tho.....but thats just me.

on the f4i, its a dark green w/ black striped wire at the corner of the front harness connector.

 

okay perfect, so u don't need a toggle switch

just use ur headlight controls.

u have 2 choices:

1. temporarily (or permanently) ground the 2 ground wires, leave the controls on highbeam, and connect the other wire(s) to the harness wires...one by one...look for it to turn on as you go. when it does turn on, switch controls from highbeam to lowbeam, if the light turns on, you know that you've just found the highbeam wire

OR

2. if you have access to a 954 frontend (headlights)...look at it and its connector and follow the wires so u know wats wat.


p.s. do you have the tip-over bypass?

 

i cut the highbeam plug off and just touched wires till all 3 worked on highs... put it on lows and lights are off... pretty simple

 

+1