check my edit check both sides of the plug like that with the clip on the neg of the batt

 

i know it has to be something simple and stupid

 

did and still nothing

 

check your kickstand switch.

 

is you batt dead..if not tap on the relay with a screw driver or some thing small and turn the key on and off at the same time while the pump is plugged in

 

its bypassed. but even if taht was it wouldn't the pump get power?

 

dude i wish you lived close .this is just a big lack of communication......

im going out for a smoke........lol

 

double check your kickstand switch and clutch switch

 

well like i said i hit the started and it cranked but only like twice so i put the batt on the charger...but it can't take that much power to power the pump for 2 seconds

 

clutch is good i already checked that i'll check kickstand switch you think the wires came apart?

 

if the batt is too low it wont send the signal to prime the pump....

 

i think double checking is a good thing, just sorta sit there n stare. don't focus just stare and think of what u took appart/cleaned/moved that could effect any connection

 

ahhh well hopefully it is that simple

 

wheeliest correct me if im wrong here , but if he grounds the test light on the neg side of the batt , and puts the probe side on the hot side of the plug , and turns on the key , assuming all the switches like the kick stand and clutch and tip over are all by passed correctly and the bike is in nuertal so it doesnt run him over ,,,,,,shouldnt he get a completed circuit ?

 

any neg spot, doesn't have to be off the battery.. but yes, it should lite ur test light up.. ima man of the spark test test lights are trendy

 

go i guess i triple check my switches again cuz im not gettin power there

 

haha yea and you like to replace fuses too....

so after that he should test his relay well fuse first then relay

 

all fuses are good

 

how do you test relays?

 

first check to see if there is power to the relay then if there is try like i said tapping on it with a screw driver ,if that makes the pump come on then you need one ....if not you can just swap it with another one to see if that works cause im not even gonna go thru trying to teach you that without being able to just show you first hand