I know it's already been said but I got this same noise before. rebuilt and rechecked everything on the front end.. It was still there. Finally I traced it to the cage motor mount bolts. Think back if this started happening right after you dropped it or just over normal time they can lossen up by themselves. They will make that creaking noise when pulling endo's or under very hard breaking. I spent a whole weekend tracing it down. Just at least check them first and torque them back down and try it before going through all the trouble. A 1/4 turn will allow them to make a hella racket with the alumn/steel/aulmin/ creak.

 

my **** creaks like a mother fukka...

tightended a lot of **** and said ****it.....id tighten the motor mount bolts but my cage is a lil stuck on right now...

 

Hah, I haven't tightened the side motor mount bolts since that wreck. I'll check that tonight, thanks!

 

99% sure.. mine creaks all the time... but I practice hard so I tend to drop it at least once a session

Let us know how it goes mang!

 

i have recently put on a 954 front and after a couple days of trinna stoppie it started feeling like there was anti lock brakes and the front would shake violently under hard braking and even when i tried to do rolling burnouts.. i checked the rotors for runout and it was between .002"-.005", didn't think that was enough to consider the rotors warped so i replaced the front pads. thought it went away but later in the day it started shaking again. any thoughts. imma try to do the realigning the forks tonite.