Anyone out there using aftermarket clip-ons on their 636? Im thinking of buying a set so I can set up my handbrake a little farther from the grip. I just dont want to change the riding position too much, Im worried that aftermarket clipons might make me lean forward or down more?

Let me know what your using and how it feels compared to stock?

 

Freestyleingenuity.com Has What You Need.

 

NICE! have you tried them? I wanted less angle but those are 0 degree not sure if thats what I want..........might be too close to dirt bars for me

 

No.haven't Tries Them But I Heard They Are Nice.i Will Be Getting Some Soon Cause I Bent My Clipons Yesterday

 

Any Idea what the stock angle is? Im looking at different clip-ons and they seen to range from 0-9 degrees.......I just dont know if straight is what I want

 

www.woodcraft-cfm.com

been running them for 2 years with no problems. easy to change bent clipons. they SLIGHTLY lower the reach, but no really noticeably. i'm 5'9'' and reaaaaly like the aftermarket clipons.

 

Thanks I was gonna go woodcraft just cause Im already getting their rearsets
When you say they lower the reach is that because of more angle or because clipons usually are more forward because they go infront of the fork tube?

 

i put a handbrake on mine without aftermarket clip-ons. I used stock but i had to remove the chock/headlight low/high/turnsignal switch and cut down some of the grip.

 

So did I but Id like to move the clutch 1/2" or so more towards the tripple clamp........Aftermarket clipons will allow me to do that as well as hopefully give me less downward angle on the bars.