how do u mount the FI 12 bar on a 01 f4i? someone give me a how to or something

 

grind them round tabs and welds off the subrframe drill holes and mount that ***** up

 

line up the bar to the subframe(take the tail plastics off),mark the holes and drill them accordingly.......make sure the 12 bar is at the bottom of the subframe and then at the top......it is made to be at an angle....(sort of like this / ) then just drill the holes and bolt it up........just be careful not to cut too much of the tail when putting it back on

 

I have 636. Should be the same.. My 905 came with holes drilled in it already. I grinded down the welds on the subframe then put the bar on and measured and drilled the holes and bolted it on..Was pretty easy

 

isn't there some wires and other things in the way?

thinkin bout the 12 bar on my ride, but haven't looked into it much yet...but i recall that there's some crap in the way where you need to drill...