I've got a 929 brake lever with a line down to the rear master cyl. I used plumbing fittings and jb weld to attach the fittings to the old reservoir hole on the rear master. Basically its manny's setup.

I can't seem to get fluid down to the rear master. I don't know if its the way i have the reservoir or what. The reservoir is above the lever but the hose dips down and then comes back up. I remember reading about how some people were bleeding it off the bike or something. I figured that the suction from the lever would pull fluid up into it and then into the system but it isn't seeming to work. I plugged the intake on the lever with my finger and pumped the rear master it got a vacuum so everything is air tight. Can someone give me some help here???

Jon

 

check with shwartz he had a complete how to bleed on the hand brake..

lots of details and ideas.

 

can't find anything. Got a link? Anyone else got any ideas?

 

hold the master cylinder in your hand and pump it, it doesn't bleed well when it's upside down.

 

Lots of topics he helped out in.

I did a search using the name Schwartz, searching only the How-to forum in the last 6 months and came up with these results:

https://www.stuntlife.com/forums/sea...earchid=371458

Hope this helps.