what do you use to cut your tail section or any other fairings for that matter?? Any definite do's or do not's??

post up

thanks

 

I used a utility knife, file and tinsnips... yup.. I'm sure theres a billion better ways.. but it comes out pretty good!

 

rotozip, dremel im sure would work fine.

 

Tin-snips, plastic hack saw blade, dremel tool and sand paper... take your time, you can always take more off, but you can't put it back (well you can but its a hell of alot more work)

 

hack saw, dremel, utility knife...

 

Whatever you can find...

 

scribe a line w/flat head screw driver ,then break w/pliers works fine

 

Razor blade works, just be careful not to slip and scratch the rest of the tail.. or your finger

 

maybe some sizers. or a steak knife cuz those are pretty sharp.

 

why dont we just use a MAPP torch and melt off what we want to...

 

 

lmso.. in my early repair days, I bought a propane torch and tried to do a fender eliminator on my SV650S.. I cut most of the fender, then tried to heat a part of it so I could bend the plastic down.... I set the whole fvckin thing on fire... it was pretty funny.

 

i like to use the clutch gas and rear break

 

dremel and a hacksaw