well i finished my 12 bar today. needless to say, it was easy to make. i parked it to make sure it would park right and it does, sits a little to the left, in the pic looks more than it does cause if the driveay is all effed up. but came out real clean.


a few quesiotns. the bike parks fine. it sits to teh left a bit but doesnt seem like it will be a big deal, do you think its ok? i painted it with flat black, made a brace from one side to anotehr to avoid flexing.

enjoy! these are imagestation pics so some might show and some wont so bear with me whiel my website gets remodeled so i can post better pics

 

all I get are red Xs

 

 

i see 2 of them...

I dont know if this is correct, but if its cocked to the left like that (right in pic duh) wouldnt that cause the bike to track to the left? One side of the bar is goin to have more weight applied to it beings it sits crooked.

 

it'll wear

 

All I see are red x's too!

 

right click on the red x's,
click on properties, copy the address and put it into your broswer .

hope that helps people see it.
i see them and it looks like the bike is leaning to the clutch side in the last pic, but i could just be the angle.
looks good though.
test it out..

ps you should have done a write up on "how to make your own 12 bar"

 

whats that I/C in the backgroud go to ??? i like the bar, put a TI block on it

 

you were the foo telling me not too

i am going to put one on. i think it will be fine, my buddy was liek "when you sit on it, it snot like your perfectly level anyways"

teh IC in teh backgrond was on my car.
an 8v turbo VW. i made it turbo. going for a water ic setup this spring for drag season.


BTW, there will be a write up with these if not betetr pics for my website www.evoeone.com its getting revamped, its totally crappy now, but it will be the heat when its done :YEAH

 

bump for critique, tips, comments etc