i need to know how to wire the kickstand so you can start the bike and run the bike witht the kickstand down.
and i need to know how to rewire so my bike will start in any gear.
if you havent personally done this please dont answer. i dont want to **** anything up on my wiring harness

 

kickstand is the two wires that go to the actual kickstand... i forget if they need to be wired together or left apart (i think wired together) and thats it.

assuming you have an EZ-pull clutch lever/perch, the way i do it is to jump the two wires together that make the bike think the clutch is always pulled in... its the two wires that normally hook up to the stock cluth perch...

there are probably better ways to do this stuff, but this is how i do them real quick... ill be waiting to here from others for better solutions...

 

john to the rescue, thanks man....i figured this was the way to do it haha pretty easy, i would rather do it this way than hack into the main harness.

 

no problem bro... also, if you want to get creative, i have used staples and paperclips in the stock connectors to make the jump so you dont have to cut them off (ie, you dont cut anything off your harness so it still has all the stock connectors and can be returned to stock)

once you know you have the staple/etc in the right spot, use tape or something to make sure it doesnt come out...