I want to get a round bar for my 04 R6 but I can't find one.
Anyone know were I can get one or if someone makes them?
I don't want a flat bar yet I won't be doing scrapes for a while.

 

get a standard bar, cause if you go back to far, slip off the brake, get scared it will land on the bar and not f%^k up the bike.

 

really?I dont think so...

 

that's not going to happen unless you're straight enough for it, it's gonna get nasty.

try MXD or 905 for a round bar.

 

either way i hit ur tail to hard on that r6 u can expect it to crack your sub frame..

 

yep. **** putting a bar on an r6 thats just asking to blow up numerous subframes. hope you got a good buddy who runs hella tig who wants to devote lots of man hours to that thing!!!

 

If you can, have your subframe boxed and reinforced BIG TIME before you start thinking of tossing round bars, 12 bars, or any bar for that matter on a yami subframe. They are garbage!

 

yea i want to put a bar on mine too (05) but i dont have a tig ( i know how to tig weld but dont have one) and i dont know what all to box/ brace/ strengthen...

 

THE WHOLE THING!!! They commonly snap though up at the frame where it connects. Just a weak design for stunting!!

 

box the sub, box the sub mounts, box motor mounts, n once again box the sub onto the frame all with half inch aluminum.

 

I looked at both sites and all they have is flat bars

 

What are you using?
I'm learning still, but a round bar would be a lot gentler on my bike in case is fu(k up, which is bound to happen.
did you start out with a bar?
I dont care if its best just to scrape the tail.

 

u gotta actully talk to the Guys that run those sites, these guys play with metal more then their web sites LOL

 

my sub frame isn't weak but i had a few get offs and my tail light/plastics took all the damage. i'd suggest NO BAR but keep spare tail lights n ****. and i HIGHLY suggest getting rid of that R6, it is NOT a good learner bike unless u have a dedicated welder. your going to lose motor mounts on that frame and go through lots sub frames. i learnd with no bar and learnd to scrape my tail 10 times in a parking lot all in one wheelie till i put a bar on.

ps: i have a flat bar...

 

Yeah I think I'd rather scrape plastics unless I can get a roundbar.
I don't really want to do long scrapes, I just want to be able to.

 

sickinovations makes round bars not sure if they make them for r6 though

 

thanx I'll look into it

 

the way i see it and how i talked myself out of a bar is, scatched tail on ebay = 30-65$, tail light (which i broke the other night o my 2nd scrape) on ebay= 30-70$, or a subframe on ebay =150+$ just my 2 cents

 

I don't know
I went to the site but can't get ahold of them

 

i havnt seen one yet, also scrapeworks is working on a subframe for the r6 that isnt cast