M4X1MU5

Right i took my fuel pump off the other night and when i put it back on it leaked (badly) so i tried again same thing happened?? my rubber seal looks intact i was wondering do you have to re-seal them or something? i cant get my head around it. anyone else had this happen to them? and theres a metal kitchen scrubber like mesh around my fuel pump is that supposed to be there? i guessed it must be a filter or something but then again there was some ratchet pieces in the tank too i dont think they should of been there

N2O

Yamabond 5

adam h

the wire wool is supposed to be there! make sure the gasket is sat properly, ive never had to re-seal any of mine

xxMICKEYxx

look at the edge of the tank (where the seal goes) and make sure its not bent.

-Ludo

I know whats wrong there mate, its easy.

The honda thing is broken and it needs a new 636. If you buy a 636 it will fit right in and problem sorted. If it still not right at first but a 05 636 and bobs your uncle

Turtle

i had the same problem man...spent like 3 hours messing with mine and finally got so fed up I got another gasket and just doubled up....I was so furious I couldn't believe it

shane636

my fuel pump went in mine man, but when your putting back on the rubber gasket to the pump, you have to pull the nipples on the gasket threw the holes on the pump til they click in place to secure a prefect seal.. and that metal gause is ment to be there!

M4X1MU5

Thanks everyone il give it another go when i have a new tank.. i only went and snapped the bolt on my tank didnt i Lee i perfer the F4i to 636's i havent tried the 05 one yet so bring your self and vertical trix's wheelie machine to the pod