help me fix...'05 yamaha yfz 450

Thread Tools
 
Search this Thread
 
Old Dec 5, 2006 | 08:29 PM
  #1  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Exclamation help me fix...'05 yamaha yfz 450

my yfz is f*cked up rite now. i dont know whats wrong with it..keeps leaking gasoline and makes a noise like theres fuel over-flow.. (i dont have a mix just 91 or higher)and its shutting off after a minute or so..changed the spark plug..battery..c-shaft..jets and the fuel line are fine..i dont know? damn it..i went for a ride last week,when we got that yama-ha-ha(yeah i believe yamahas are sh*t but i still like'em)to run..and then i had to push it for like 4 blocks back to the garage..lol..what a workout LOL..maybe someone can give me some suggestions as to what the hellz wrong wit it..?


help me please..anyone/mechanics in the chicago - land area..

...i'll pay ya 2 fix it.....

thankxxxx
Old Dec 5, 2006 | 08:45 PM
  #2  
jd450's Avatar
Registered User
 
Joined: Jul 2006
Posts: 77
From: lusby, MD, U.S.
jd450 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

have you wrecked it, flipped it at all? i had a '05 and had a pretty bad spill on it. i had some of hte same problems and couldnt find out what was wrong w/ it. it ended up being the carb. the needle was stuck up in the seat. my quad wouldnt seem to start. when i DID....which was hardly ever, it would run for a FEW seconds then shut right back off. i hope this was SOME help to you.
Old Dec 5, 2006 | 08:54 PM
  #3  
JD_ATC200's Avatar
Registered User
 
Joined: Oct 2005
Posts: 227
From: Southern, WI
JD_ATC200 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

Definetly check the needle, or check the float, clean the carb, get all crap out of there.
Old Dec 5, 2006 | 09:06 PM
  #4  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Re: help me fix...'05 yamaha yfz 450

yeah i flipped it a couple times...i kept on doin' wheelies...i have checked the carb AND cleaned it..thats why im puzzled as to what the heck is still wrong with it..any other possible suggestions..?
Old Dec 5, 2006 | 09:08 PM
  #5  
jd450's Avatar
Registered User
 
Joined: Jul 2006
Posts: 77
From: lusby, MD, U.S.
jd450 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

Hmmmmmmm, im not to mechanical. so im stumped! my only guess is the carb. and you said you ruled that out, so idk. i hope you get it fixed though, and its nothing major.
Old Dec 5, 2006 | 09:11 PM
  #6  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Re: help me fix...'05 yamaha yfz 450

SEE its driving me insane..i was sure it was the jetting..but NO! i almost get mad just thinking about it..cuz its the 1st time ever something like this has happened to me....makes me saY "YAMA- HA..HA.." EVERY time..piece of Sh^it....
Old Dec 5, 2006 | 09:12 PM
  #7  
jd450's Avatar
Registered User
 
Joined: Jul 2006
Posts: 77
From: lusby, MD, U.S.
jd450 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

anything electrical?
Old Dec 5, 2006 | 09:13 PM
  #8  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Re: help me fix...'05 yamaha yfz 450

cant be...i put-in a new spark plug and battery..check all the wireing..and now im ..??????????? mad? lol
Old Dec 5, 2006 | 09:16 PM
  #9  
jd450's Avatar
Registered User
 
Joined: Jul 2006
Posts: 77
From: lusby, MD, U.S.
jd450 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

well ****! im stumped, lol. i would assume carb or electrical, and you've checked them all.

Old Dec 5, 2006 | 09:20 PM
  #10  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Re: help me fix...'05 yamaha yfz 450

Originally Posted by jd450
well ****! im stumped, lol. i would assume carb or electrical, and you've checked them all.

yeah and from all the thinkin and plucking i've done to the quad..im gonna loose my hair soon lol j/k
Old Dec 6, 2006 | 09:21 AM
  #11  
slinky750's Avatar
Registered User
 
Joined: Oct 2002
Posts: 4,250
From: Upstate NY
slinky750 is a decent person
Re: help me fix...'05 yamaha yfz 450

sounds like your floats are stuck. pull the bowl of the bottom of the card...take the floats out and the needle set...clean everything up real good. take all the jets out and make sure you can see through them. blow some compressed air through all the ports and make sure you soak it all good with carb cleaner. If gas is just pissing out of it usually its due to a float stuck open. Your bowl is filling up with too much fuel then its pissing out the overflow.
Old Dec 6, 2006 | 09:48 AM
  #12  
shadywitthe380's Avatar
Registered User
 
Joined: Oct 2006
Posts: 127
From: valley falls, ny
shadywitthe380 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

Originally Posted by slinky750
sounds like your floats are stuck. pull the bowl of the bottom of the card...take the floats out and the needle set...clean everything up real good. take all the jets out and make sure you can see through them. blow some compressed air through all the ports and make sure you soak it all good with carb cleaner. If gas is just pissing out of it usually its due to a float stuck open. Your bowl is filling up with too much fuel then its pissing out the overflow.
or your float level is wrong, check the float make sure it still floats may have a pin hole....I'd say it could be the float level which service manual can tell you the exact measurement it is suposed to be...check the float needle has a little rubber tip make sure it is clean...hope this helps ya...
Old Dec 6, 2006 | 09:56 AM
  #13  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Talking Re: help me fix...'05 yamaha yfz 450

Originally Posted by shadywitthe380
or your float level is wrong, check the float make sure it still floats may have a pin hole....I'd say it could be the float level which service manual can tell you the exact measurement it is suposed to be...check the float needle has a little rubber tip make sure it is clean...hope this helps ya...

youre awesome..
LOVE YA!
...im gonna take it apart again...hope youre right..
Old Dec 6, 2006 | 10:44 AM
  #14  
slinky750's Avatar
Registered User
 
Joined: Oct 2002
Posts: 4,250
From: Upstate NY
slinky750 is a decent person
Re: help me fix...'05 yamaha yfz 450

Originally Posted by shadywitthe380
or your float level is wrong, check the float make sure it still floats may have a pin hole....I'd say it could be the float level which service manual can tell you the exact measurement it is suposed to be...check the float needle has a little rubber tip make sure it is clean...hope this helps ya...
thanks thats pretty much what i was getting at...i'm a little slow with my wording this morning lol
Old Dec 6, 2006 | 12:02 PM
  #15  
shadywitthe380's Avatar
Registered User
 
Joined: Oct 2006
Posts: 127
From: valley falls, ny
shadywitthe380 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

Originally Posted by NIUNIA
youre awesome..
LOVE YA!
...im gonna take it apart again...hope youre right..
definitly sounds like a carb problem,do you have a service manual?
Old Dec 6, 2006 | 12:22 PM
  #16  
NIUNIA's Avatar
Thread Starter
Coldhearted Evil
 
Joined: Nov 2006
Posts: 116
From: Chi 'til I die
NIUNIA is a decent person
Re: help me fix...'05 yamaha yfz 450

nope...i did but dont even ask where its at...if i only knew..haha..
Old Dec 8, 2006 | 05:45 PM
  #17  
KtownRedneck89's Avatar
Registered User
 
Joined: Apr 2006
Posts: 32
From: kingsville
KtownRedneck89 is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

have u taken the jet out and blew an air compressor trough it mine had that problem too jus try things ppl tell u dont take it somewhere thell charge u alot and still not fix it
Old Dec 9, 2006 | 08:27 PM
  #18  
Gichie's Avatar
Registered User
 
Joined: Nov 2006
Posts: 59
From: Montego Bay, Jamaica
Gichie can only hope to improve
Re: help me fix...'05 yamaha yfz 450

I think this is a carb problem, you need to get the carb properly cleaned & blown out, then check the engine oil cuz sometimes when you have an overflow problem gas goes into the oil through the cilinders which could cuz you mo problems.
Old Dec 19, 2006 | 02:15 AM
  #19  
thewibb's Avatar
I Enjoy Posting At StuntLife!
 
Joined: Jan 2003
Posts: 1,200
From: St. Louis, Mo
thewibb is an unknown quantity at this point
Re: help me fix...'05 yamaha yfz 450

Originally Posted by shadywitthe380
or your float level is wrong, check the float make sure it still floats may have a pin hole....I'd say it could be the float level which service manual can tell you the exact measurement it is suposed to be...check the float needle has a little rubber tip make sure it is clean...hope this helps ya...

EXACT same thing I told her in the other forum. Those bikes are notorious for that float needle gumming up and sticking causing the float to become stuck which in turn causes gas to pour from the overflow. Reason I know is because I have 2 of them.
Old Dec 19, 2006 | 02:14 PM
  #20  
KUTZ's Avatar
Quad Ridin Ninja
 
Joined: Sep 2004
Posts: 2,484
From: Wisconsin
KUTZ is a decent person
Re: help me fix...'05 yamaha yfz 450

Cracked Float or Bent needle
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
kenny_ktm
Newbie Welcome Center
0
Sep 27, 2015 06:23 PM
eniscinar
Stunt Bike Videos and Reviews
0
Aug 19, 2014 05:49 PM
clepire
Bikes Wanted
0
Feb 3, 2013 08:32 AM
shady
XR50 & Minibike Forums
49
Sep 14, 2009 11:07 PM




All times are GMT -4. The time now is 11:10 AM.