Raptor very slow wheelies...
Thread Starter
Registered User

Joined: Oct 2005
Posts: 12
From: Nancy France

Raptor very slow wheelies...
Watch my new video and tell me what do you think about it...
http://videos.streetfire.net/search/...BECB7A4C15.htm
http://videos.streetfire.net/search/...BECB7A4C15.htm
Thread Starter
Registered User

Joined: Oct 2005
Posts: 12
From: Nancy France

Re: Raptor very slow wheelies...
Thanks for your comments.
For AustinZ400 i prefer to do slow wheels i find it nicer than fast and everyone can do fast wheelies...
For mnchvgs79 this kind of music is call Reggaeton and its not a circus music hahahah lol
For AustinZ400 i prefer to do slow wheels i find it nicer than fast and everyone can do fast wheelies...
For mnchvgs79 this kind of music is call Reggaeton and its not a circus music hahahah lol
Re: Raptor very slow wheelies...
when i do slow wheelies and go back too far i always stall it out when i hit the brake, i find it hard to grab the clutch when i am trying to hold on at the same time...any suggestions?
Re: Raptor very slow wheelies...
Originally Posted by chpsk8er630
when i do slow wheelies and go back too far i always stall it out when i hit the brake, i find it hard to grab the clutch when i am trying to hold on at the same time...any suggestions?
Keep a finger on it with the other three wrapped around the grip so that you always have a hold of it.
Re: Raptor very slow wheelies...
Originally Posted by telefonica600
+1 I saw Kelm spreaders on a quad!!!!

These video's keep getting weirder and weirder not that it was bad but just not what I'm used to seeing.
I'm used to faced pace FTP kind of stuff and that did kind of sound like a circus i would know I was born at one
Last edited by KUTZ; May 25, 2006 at 01:50 PM.
Re: Raptor very slow wheelies...
Originally Posted by z400doawheelie
were you stunting in an aldi foods parking lot???
because, there is never anybody at those and i just might have to take the z to one...

because, there is never anybody at those and i just might have to take the z to one...

Thread
Thread Starter
Forum
Replies
Last Post




