Adding the extra potential for hardware failure.

 

Mike are you talking about a push/pull throttle cable setup??

 

more accurate throttle control

 

yes

 

so how do you start convo's with girls on myspace

 

So you want a smaller pulley than what is in there right now? I would think a smaller pulley would see less force.

 

Ask them if they want to go for a ride and check out a donkey show.

 

Insults. Lots and lots of insults.

 

yes im that bored

 

hmmm that might work

 

tell them a joke

 

Me too. I just went and checked out one of our gravel pits to see if I can get in there with my dirt bike. I'm not sure how they'll feel about it since someone died there a couple years ago and we are getting sued now.

 

preferably a racist one.

 

I have a ton if you are interested.

 

that's actually what my dirtbike has.....I think most of the hondas do now.....might not have to fab one up.....

this is from the project 230 article I used to setup my bike

The Honda is incredibly complicated and even has a dual cable push/pull throttle.

 

a smaller pulley on the throttle tube would be perfect, but the f4i's is already very small. If it were channeled smaller, the plastic that the cable rides on would be very thin. too thin in my opinion

 

you don't meet nice girls on myspace.....so the answer is....DON'T

 

Crazy ******.....

 

all modern sportbikes have dual cables. what i was specifically talking about is a little reduction box of sort.

 

all the nice ones have their profile private