Ok.. I know I'm an engineer but I do plastics not electrical..

Anywho, I tried wiring up some new rear turn signals, LP Short Stalk LEDs on my F4i...

They have 1 positive and 1 negative wire.. The F4is have a 6 wire circuit cuz the license plate light is also tied in.. I dont use that light though.. Does any know how to wire this **** up... Oh yeah.. I managed to blow out my guages in the process..

So if someone can tell me where my fuse box is too.. That would be great!!!

Thanks!

 

LMAO

isn't the fuse box under the seat on that bike?

 

I think so. Ive just been too lazy and had no time to go out there and pull it off.. I hope its only the fuse tho.. Its a pain not having a gas guage.. I could care less about the speedo...

 

this might sound stupid, but did you look at the stock lights to see how they were wired. When I changed out my fronts it was really easy, and if I'm not mistaken it's 3 wires. If you bought 2 wire short stalks, you need to exchange them for the 3 wire set up. I'd take a look at mine to see, but my bike is in my parents garage an hour away from where I'm livin now.

 

bring it by I will do it.

 

he doesn't need running lights just signals

 

Yeah.. they are 3 wires each, but they say this is a way to do it....

Thanks Tim.. I will bring it by one day this week or sumpfin.

 

grab a test light and figure out what lead is hot with key on ignition, then find the turn signal lead, and the third is ground. easy...just don't go and try to integrate a honda...they suck.

 

See thats why u need a suzuki.... Its all in the taillights...

 

pfft i seen your hack wiring job on my POS !! lol

 

Just buy the tailight integrator kit, put your signals right in the tailight, i have it on my 929, it works great........

 

I already bought this light kit.. Plus I have seen those integrators go bad after a couple of months..

 

That was shiffty. Your car works doesn't it

 

umm theft light still comes on !

 

My trunk dont pop.....

 

That wasn't wired wrong I just forgot to do it

 

My R1 is integrated just fine with new LED lights going in as soon as I start reassembling it.

 

go try and upgrade to windows xp Pro again ! ****