you could be spending time getting your trac(tor) bike back to street legal

 

3rd post.......I'm slippin'

 

4th post ha HAA

 

I will be 1st tomorrow

 

Compton, I thought you were getting a job at WacArnold's cookin french fries! You'll be too busy to post then.

 

Im not gonna have to worry about having a job when Im in prison for bulldozing the UPS building. Those ******* are pissing me off

 

Just rode a bone stock minty F4I. It was all I could do to get it up in 2nd on the highway......it was fun though. I do al my street stunting on customers bikes now

 

HAHAHA...note to self, never take your bike to Andys shop

 

just basic standups and sitdowns so that doesn't count

 

unless I was riding an SV650

 

ohh yea,forgot about that We are getting a stroker crank for the SV now, its gonna be a 754cc SV:YEAH I also fucked up 1 gixxer 1000

 

BTW, rumor is that John got a job wrestling with the MWA. Its just something to get him and brittany by until they make it big and get on Jerry Springer

 

Beau I need to give you the tape of Jerry busting his a$$.

 

where is everyone this plase is dead

 

Yeah my pre dented tank that now has a lazy bowl dent is requiring a lot of bondo.. I hate body work.... but I hat trashed bikes too.... I guess it's getting spray bombed until I decide to tear it down and pimp it in late jan or feb....
Wish someone would comment back on the exact instructions to put an 05 swingarm on a 03 636.....

 

I thought Compton knew how to

 

i know how you 1st get the nut off of the thing that holds the part that pushes the arm to swing to the left then you talk to your self and smoke a smoke and start that sept all over again

 

Compton is the one who told me how to do it

 

 

damn you lazy bastard, couldnt call someone?

You'll need the swingarm, caliper carrier, longer rear brake line from an 05-06, 05-06 rear rim and axle with the factory spacers, the links and dogbone.
You can use your shock and the swingarm pivot axle up front. You can also use your sproket, cush drive and rotor from your 04 rim on the 05-06 rim.

On your 04 swingarm on the right side there is bolt that is square and threaded, you'll need to keep this, you'll also need the dust shield on the right side. (just pry it up with a screw driver)

On the right side of the 05 swingarm, pry the dust shield off and replace it with the one off the 04 one. You will not need anything on the left side. When you put your rear shock in place you'll need to swap out the linkage because the bottom mount for the shock is bigger then the 04's mount. Attach the shock, then the dogbone, links etc..

You'll have to pull apart your chain to run it threw the 05 swingarm. Once you tighten everything down use a plumb bob to make sure that it is centered, which it should be and thats it.

AnyWant me to walk you through an oil change too?