where can i get a 12 bar for the 954 ? best one?

what woud u suggest for the frame sliders?

thanx for all ya help with this dam bike...

 

most people just make there own bar by takin a few peices of metal and welding them together

 

just remove your tail plastic, use C-Clamps and clamp two pieces of metal, alum or whatever your making your bar out of to the subframe. then measure the gap between the two bars. cut a piece to match the gap. then remove clamps and weld piece in middle of two brackets. piece should look like a " U " now. but square.

remember before you weld the thing together to tilt bike back and cut your 2 side bars on end to match angle of flat ground. other wise when you mount your 12 bar on bike it will not sit flat!



mount it back on bike with clamps. then tip your bike back in 12 position. once you get bike straight up and down tighten clamps, this is where you want your bar to be. tip bike back down. I drilled holes and then mounted it with 4 bolts. you can mount in however you want to.

this should get you in direction, if you have any ??? holla

 

I want a 12 bar on my BMX bike, is it possible to have a removable one?

 

anythings possible

 

thanx for the info crazy dan


hey what frame sliders would u reccooomend ? i know in one of your replies in another board u said get long ones...what woudl u suggest?where do i get them?

 

thay have them at www.kcsmostwanted.com thay are there for sale