x2weelz

I need some info about puting 05 636 wheels on an 04 363. Will they fit, and most important will they f up my .

John LegionST

front bolts right up, rear you have to use an extra spacer or two, search it on here there are a few threads that show you how to do it.

Suicidl

the rear you have to use a extra spacer on the brake side of the wheel then space the caliper over also. or you can just do the whole swingarm swap

Greg Mcglynn

Dam ***** that exhaust looks clean. What kind is it and how loud is it.
I might have to go that route.

Suicidl

it is a jardine from a f4i and it is not that loud at all unless you are ***** out rev limiter

Suicidl

looks better than this

Greg Mcglynn

Is it a stubby or you just cut it down.

does is have setting #5? cuz I'm looking for one with that.

Greg Mcglynn

I need to cut down my stock pipe on my stunt bikes. The other day I was doing low circles and the pipe scraped the ground so hard it caught and I had to bail


That doesn't look so bad without routing the exhaust through the swing arm hole.

x2weelz

how bout the mount for the 05 swing arm...it uses the same parts as the 04, by the way that bike is sexified...

Suicidl

i cut it down then used a piece of 05-06 636 midpipe to go on to the header to give it a angle out then mounted the pipe to that

Suicidl

get the whole 05-06 636 swingarm, brake bracket, axle, shock, shock mount, wheel and wheel spacers. then all you have to do is take the nut part out of the 03-04 swingarm and the seal on the brake side and put it in the 05-06 brake side and bolt it up

x2weelz

Bout to buy that shhit righ nao . Thanks