Did you change it up?

 

i want to go mow the grass......mike is there anything special i should know about the mower?

 

Air box is just like 10 screws. The tank is a pain in the *** because of the fuel line and I have to worry about scratching the paint.

 

Don't run over anything but grass.

 

Don't take the tank off.. Just lift it

 

OMR SUBCAGE (S)

OMR SUBCAGES available:
Honda

• CBR F4i - 01, 02, 03 will also fit the single seat style with minor mods
• CBR 954- all years
• CBR 929- all years
• CBR 600RR - 03 , 04 , 05 , 06 , 07 <<< click here

Kawasaki

• zx6r/rr (636) - 03, 04, 05, 06 07 08<<< click here

Suzuki

• GSXR 600/750 -00, 01, 02, 03, 04, 05
• GSXR 1000 -01, 02, 03, 04

Yamaha

• R6 - 03, 04, 05 <<< click here
• R6s (old body style) - 06, 07, 08

$175 Shipped
pay pal accepted

Tech

• The 03-06 CBR 600RR , 03-05 Yamaha R6 ,03 04 gsxr 1000 and the f4i pegs are lowered and moved back and out for better peg position!
• The 01-03 GSXR 600 and 750 have the pegs moved out two inches because of the big tail section
• THE 07 600RR pegs are located 2-1/2 inches lower and 3 inches wider (Than stock)
• All other omr subframe cage models are in the stock location except they are rotated on their axis so they don't fold up unless you fold them up, this also puts your foot on the grippy part of the peg during a wheelie.
• omr subcages are available for all makes and models but only the ones listed above are available for shipping

click here to contact >> old man roger

the original folding peg subcage!!!!!!!!!

>>click here to see why i only sell folding peg subcages<<

 

good luck to him

 

I filled up the cup past the line til there was no air or room for expansion. And thats it, i didnt bleed it yet, but it works. Not as good as it used to but good enough to get the job done

 

not that i know of. i honestly havent even looked at it.

the left shed door is screwed shut, dont pull on it

 

 

I'm not even going to do that for a mod that will probably make no difference on my bike. I'll wait until I'm in there anyway.

 

It isn't that bad.
Word
Yup, there is a holding rod under one of the seats.
good tip.

 

What color frame would look good on my bike if I had it powdercoated instead of polishing it?

 

I don't think I have a holding rod.

 

if you have an overhead beam in your garage, tie a rope to the front of the tank to hold it up

 

my bleeding equipment is at my old garage still.


yes i realize a clear tube costs like 2 dollars but i dont want to have 2 of them laying around

 

Youre both nuts. If your bathroom is a 10 second walk away why not just use that instead of pissin in your backyard

 

well...it won't start. there is some gas in there....but i can see the bottom so i'm assuming it might need more, or i don't have enough juice in my arms to start it

can we keep it in the garage instead of the shed? it's a bitch to get out of the shed

 

no **** thats cool

 

Anybody have an extra 954 swingarm kicking around?