c&c ,cnc ,tamato ,tamaato ,two stroke ,two cycle....lol

 

I'll cut you!!!

 

CNC
The abbreviation CNC stands for computer numerical control, and refers specifically to a computer "controller" that reads G-code instructions and drives the machine tool, a powered mechanical device typically used to fabricate metal components by the selective removal of metal ...



i looked it up because i wasn't sure how to spell numerical ..lol

 

just measured the f4i fork

 

but remember the 929 has a 'drop' upper clamp where the f4i and rc both have flat clamps

 

monster fiddy is back in 1 peice!!!!:YEAH

time to add oil and gas

Then IF I wired it right it should come to life!!!:YEAH

 

And its snowing out today so the test ride should be fun....lol

 

huh....there all too short.......

 

**** rog all these squids are driving me crazy

 

lol.......

you choose to deal with them in your own special way.....

 

you and i both tell him the same thing about the water down the carb and still he insists that he's right.

 

well i think if the filter is soaked it will make the bike run rich for a while..

 

yeah, but it wasnt it was just damp. he said water floats on gas and thats why you need to drain the float bowls, since when? this is news to me

 

yep and how does water get in the bowls from a wet filter ????

 

think im gonna take the girl out tonight she's been good....lol

 

It lives!!!!

Icey roads but I still took it for a ride!!!!

 

you can't tell how powerfull it is on the ice huh ?

 

it was all I could do just to keep it upright..every time I gave it gas the back-end slid out..

can you say clutch in both feet down corners....lol

 

And the looks I got from people in cars.....priceless!!!!

 

lucky you, i just acquired a motor, now all i need is a frame, sub-frame, gas tank, and front wheel.