wat r the technices?
i know these two use a board to align the tire with the board
useing the wall
neither of them will give the right place cuz ur aligning it with the tire full with air.and when ur 12ing the tire is kinda flat
so can i use one of these two technices and take out an inch or two to make things right?
one more i need to drill two holes on each side right?
wat r the bolts sizes?
and the width or waterver of the steel?

any help would be great
thanx

 

line the bar up with the part of the tire that has the sharp edge, it also sticks out the farthest to the side, kinda hard to explain but look at the tire from the top and you'll know. that should give you about the perfect angle. for the side to side. measure from the head bolt to each edge of the bar.

 

easiest way is to put the bike against a wall and 12 it and have a buddy hold onto the bike. hold your bike. let out MORE air than you would be running because the wieght of your fat *** would be pushing the bike down farther. line up the steel plate and the bars coming onto the subframe then wield it to the frame and TADA!!!