Hey. I was just wondering what i need to install a rear brake on my handlebar. Is it expensive, a lot off work? Just an easy way.

// Blix

 

A master cylinder, extended brake line and either a dual caliper setup or a junction valve on your rear master cylinder. You can either buy a left hand master online or buy a normal one on eBay and flip it. It can cost anywhere from just over 100 all the way up to 400 for a badass one

 

Is it bad to have a master cylinder upside down?

 

no..a lot of ppl who are on a budget run front masters flipped...i use to run one like that myself for years nvr had a problem

 

You can get a real pro set up called a Dualever, 2 levers on one side of the handle bars you can set it up to operate the front and rear brakes seperately or the brakes and clutch etc etc hydraulic and cable operation go to www.flatshifter.com

 

GP tech makes one as well. Not sure what people think of it though.
It does have a brembo master on it
http://www.thestuntfactory.com/horehabr.html

 

I'm probably going to order a rear hand brake kit from FTI, comes with a Magura master and everything you need to tap into the stock rear caliper. about $300

 

this is good for starting with but later on your gonna want to upgrade