Ight so I bought a powers cage from some one , but I ain't get no hardware with it .bummerr..but any way , I try to call powers but am not getting a whole of them.I wanted to order the bolts n wat ever.but since they ain't answering , I was wondering if I could do this **** my self.the only thing that I don't know about is the damn spacers I got to put on.so if any one could help me out , with some pics , or something .. Am trying to get this done before this week ..

 

Oo an I got the cage with the skid plate that's goes on the bottom , this cage is more complicated than any other cage...so any help will be good

 

Yoo what's up man call me up I'll try to help u out or maybe I can meet u somewhere and check it out and help u figure it out

 

O and from what I heard on here I think powers closed shot

 

Shop**

 

Wow that sucks , I got to get ya number back man cause I got a new phone I Was looking for ya number the other day. pm me it . You don't have any hardware for it ?what did you use ?

 

The cage is simple, takes me 15 minutes to pull it off or put it on. Just a huge warning though from my experience, that cage can very possibly **** your frame up. The problem is the top, most forward mounting point, the one with the 3 or 4 inch base plate that rests on the frame, you MUST put a rubber piece in there to buffer the impact between the cage and frame. OR you'll get what I did and that little 3 inch connecting plate that is SUPPOSED to distribute the force over the frame...it will punch a 3 inch hole in your frame. Personally I would NOT run a powers cage on an rr. My frame is almost touching my engine on the right side of the bike.

 

damn that **** sucks, well i all ready got it...so then i could just go get normal rods an bolts an just put that spacer in between it the frame and cage? your talkin about were the front motor mounts are rit ?

 

am not planning on keeping it for long any ways...i rather practice with this **** on then nothing at all...but am just tryin to get this bolt up..can you tell me wat you use , the size bolts and ****...i just want to rock witht his for now

 

I'te, so dis wut you gots to do. You hear? You need to pawns dat **** off on some cracker jack fo a hot fiddy dolla o sumptin and den you needs to hit up dat ATC cat and fly him some papah fo 1 uh his cajiz. U dig? HOLLUHHHHHHHHH!

 

ya doo, you dont want to b runin dat powers stuf, it be not strong and I be seein dem tweak up and messin up sum frames and shizz. pawn dat!

 

Yeah man, just saw your post... I probably won't be able to get to it until Monday but I can pull my bolts and get ya some sizes. Let me know if you already got it hooked up. Just pm me

 

 

its only takes one pancake to **** your **** up....your better off putting good stuff on to start because it will save you money in the long run