so who has done the toggle switch ignition on their f4i and what did you use? i went to radio shack and got the 5.1 zener diode and the 1k ohm resister 1/2 watt. is that the right resister or should i have gotten the 1 watt or 1/4 watt? and did you run them in series or paralel? series-one conected to the other in line, paralel-side by side with both ends twisted togeather... i still gotta figure out the kill switch n starter button wires before i can try this... all i got is the main harness, no front harness or clipon switches yet. well i got the gsxr600 front end on it and the suzuki right side switches, i just need to hard wire it into the honda harness i guess and it should work. i wanna hear this motor run before i spend anymore money on this build. i got the bike wrecked all to hell with no front end at all. the origonal frames steering neck was broke slam off but a crash cage saved the motor... i hope. it turns smooth with a ratchet on the crank shaft and all the valves checked good so i got high hopes!