Ok so I went at it again...my old brace had a weak spot and didn't last long. So check this out-I had to cut the relay box bracket partially off the subframe, to make room for this brace to run from the wheelie bar all the way down to the passenger peg mounts. I used ALL existing mount points on the wheelie bar. I only drilled 2 holes by the passenger seat to bolt that cross brace down. What do yall think. Combined with the OMR subcage, this thing is solid as a *****! Figure these pics might help someone out there to build one-these subframes are crap.

 

This was my old design Version 1.0:

 

looks good bro

 

dam double post

 

You aught to start making those and selling um on here Alvin.

Good job reinforcing the 05/06 636 subframe and the OMR subcage looks good on your baby too.

 

that aint no lie if you aint trying to get rich ill take one.

 

Looks good man......Your gonna rip your frame mounts out before that **** breaks!

 

I want one.

 

good idea. im going to try something like that

 

i really think it will take a 150mph gorilla scrape to break this thing now because if its gonna go, the omr is gonna go with it LMAO. I'm pretty confident those welds penetrated really good.

 

Ya get her back together yet Alvin? If this rain ever stops got a couple of lots to check out. Lets see if we can break something else.

 

who says u cant stunt in the rain? if my exhaust was in, id ride today

 

nice! clean it up a lil, paint it, and start sellin them! make some coin off this and you wont have to ride that huffy back and forth to the store.

 

The labor aint really worth trying to mass produce. Plus i have no clue what kind of wheelie bar people run which i would need to know. Now id be more than happy to help any local guys out just hollar at me anytime.

No huffy! I got a raincheck on a 2010 wtp envy sonnnn!!!!

 

Check out C4-Revolutions steel subframes under 10lbs made of high quality military grade steel and stronger then anything else on the market period. designed to be a direct replacement to the the stock subframe using all parts and adding supports where needed you can order them for the soul distributor for C4 items at $450 shipped from www.Moto-Psychos.com

 

Yea, I am about ready to attempt to do it like they did at XDL if this **** don't let up.

 

i was actually looking at buying one of those but the problem I see with that design is the very end where your wheelie bar bolts in. There needs to be cross bracing or an x-pattern or something back there where its single square. The single square tube of steel will NOT take the weight of the bike on the bar well-I guarantee that.

 

my brace distrubutes energy to the wheelie bar bolts, the cross brace bolts, down to both passenger peg bolts and through the subcage where its strong.

more distribution=less chance of snapping kind of like the SI 3 point cage design distributes energy to 3 points on each side

 

if you dont want to make them throw up the specs im interested in making one WITH NO R&D lol

 

easiest way to do it is to take your sub off the bike completely, measure, adjust, cut and clamp the steel straps where you want them to go on the sub so you can tack them quick, un clamp the piece, and weld it up solid then continue. takes a little bit of time, but all the holes line up perfect.