sick you make some of those (cheap) ill buy some

 

I had a different design that where adjustable on the angle that I was gonna make but then this thread was put up. Didn't want to step on anybody's toes here trying to make a buck.

 

These are made by Woodcraft right?

 

 

 

im thinking of having my risers tig'd on after i get them

 

I'ld just wait it out, Bry. If people start striping bolts, or you strip the bolts then yeah. But otherwise, if they hold up well......you'ld just be makin it harder to replace a riser if need be in the future...

 

ok my thoughts on the clipons is
pros
1. nice height
2.look good

cons
1.the two piece clamps sucks ***..having to tighten/loosen the 4 bolts to put on or off,sucks ****,because if you dont tighten them at the same rate you strip the damn head ...cause one was tighend more then the other
2.the rise peice moves around like Micheal Jackson..
3.after moving around and a few stalls later,went home to notice one bolt was cracked on each side..(out side bolt).(what the ****) glad i wasn't doing any stoppies,because if the clamp came off while doing one,(lets just say i have no job and like to travel,so i trip to the factory would have been in order)......

soooo needless to say i think they need to revise the design before some one gets hurt....
and yes i used lock tight,and that **** mine as well have been ky...because they still come loose and moved.....

 

I will forward this to Swatt and see if they address it; At this point it looks like we may stop carrying the Swatt bars until their customer service/timeliness and quality improves. We have been waiting nearly a month for our last order and if their quality doesn't improve we don't want to offer them to customers. I apologize to anyone who has had to wait an abnormally long time for these. If it was in our control things would be different.

 

they just need to do some more engineering on there end. taking all the wait off the bolts will help a lot. after looking at them for about 5 minutes there is about 3-4 good ways of redesigning without really changed the apperence much.

 

I agree, 1 step in the mating surfaces could relieve the stress off of the bolts.

I think things like this should be beat on hard before being sold to the public. Average street riders don't beat on their bars.

Stunters on the other hand......

 

i had these on my 04 r6 when i was learning idol and was mouse trapping the **** out of my bike and had no problems


i <3 endlessmoto