ok can u tell me how to do the airbox mod on my 07 zx6r please? and i also have an oil leak coming from the upper left hand side somewhere? no cracks or nothing but heard its something to do with pressure on these bikes? heard a few ways on how to sort it on here but cant find it on how to do it and what it is? please help me out.

 

idk how to do the airbox mod but have you seen the jumper mod for it? its supposed to give some decent power

 

whats the jumper mod?

 

the oil leak is your valve cover gasket, (head cover gasket). take it to your dealer and give them your vin number and they should tell you whats up. basically long story short they will repair it for you for free if its leaking. that gasket needs to be replaced. and what air box mod are you talking about? kleen air mod?

 

kawiforums has more details about the oil leak but thats the jist of it.

 

the jumper mod helps with unleash some power at the higher rpms

 

yer the kleen air mod?

 

I had that oil leak, got the gasket replaced and it returned. I believe I caused it with the clean air mod and leaving the factory T in place and active(when closed pressure builds and oil leaks) since then I replaced the T with one from the hard ware store and unplgged and took out the stock one, jumped the plug with a paper clip and wrapped it in tape. No oil leaking since. For the mod go from the T to the crank case with a hose and seal the open holes on the air box.

 

do you atleast know the idea of how it works? i can help you with detail on our bike but your probably better off looking at a 636 how to on here to get the idea... basically one difference is our pair valve thing is electrically controlled instead of vacum.

 

getting it done right for me i think it stopped the leak or maybe slowed it down. but maybe its cause i haven't been able to ride as much as i did when it was nice out side?

 

my mate is gonna do it for me dude as he has my bike and is gonna look at this thread so all the help will ba cool as much as u got guys and many thanks.

 

have him do a search for a 636 kleen air mod so he has the idea and remember to plug the holes in the air box. and completly remove the factory t-thing and just jump the white connector with a staple or paper clip like already mentioned

 

nice one buddy i sent him the link over so all is good i hope.