Well since I blew out my tail I decided to just get a flat bar... does anyone make one that comes out about 4 inches or so past the stock rear seat on an 03 636?

 

mine's a FI, i cut 3 1/2 inches off... just gotta find someone with a welder and you'll be fine

 

Yeah, I didn't know if the FI pro-length was as short as what I'm looking for or not.

 

when i ordered mine, they didn't give me the option for the 'PRO" bar, so i cut it to length, the one they sent stuck way the hell out there!

 

i had a pro bar, and it was still to long. i cut about another 2 inches off of it!

 

stick it on the subrame!!!!!!

 

I will probably take the tail off soon to see how far past the sub it will actually be. I have a pic of scraping it as-is and it's already a hair past 12, so if I put the bar where the tail ends now I will be perfect.

On a related note, are there any threads on how to shorten a 636 can without gaining noise?

 

not sure but my boy cut his from the front(exhaust exit) and it sounds like bbs in a can....

id recommend cutting the back hollow space and re riviting together....also u will problably break the stock exhaust hangar.... everybody seems to break taht ****....

 

So should I remove the rivets in the end cap, cut, and rivet it farther up the can, or should I go from the other end?

 

cut it from the downpipe side, drill rivets and take a peek see how far u can go until your into the baffles. dont cut baffles if u can help it, thats what makes it sound shitty.....

 

+1000 my next bike will be 12 barless.:YEAH

 

from this

to this



i miss the flatty