hey your website is down,,and i managed to break the cable that goes with your cable operated handbrake setup against your very detailed install instructions,,,i am an idiot please dont ask how i managed to do it but you can probably guess. where can i buy a new one?? i almost actually had it all the way bled out and am ready to start using it!!

 

holy **** that cable is ****** massive to haha.. I would think the cable would hold up before the ASV... i bled #2's and that **** wasn't close to being strained... u are horrible at mechs..

 

how did you do it ?

 

http://www.fullthrottleinc.net/store/products_new.php ????

 

Oh its .net not .com see i told you i was an idiot
here i can prove it,,i heard that it could help to stiffen your handbrake to ziptie the lever down overnight,so i did and then in the morning figured i would go ahead and gorilla bleed the footbrake a few times just for good measures but forgot to remove the ziptie,,anyway it didnt actually snap the cable but backed it out of the little metal pivot pin on the valve side...competely my dumbass fualt tho since bill has a entire paragraph outlined in bold red letters on the install instructions warning about this type of failure.....good thing it didnt happen while in a wheelie........... at least there not that expensive

 

it least your bar didn't come out in mid circle

 

You seriously should stop drinking beer while working on your bike... Maybe you should drink beer after you finish working on the bike