hey ime new to this form but i got a 2003 cbr 600rr with a bosh bros or bosh racing exhaust pipe. i wanted tyo cut down the can a lil because it sticks out so far past the tail section i took the 4 alen key bolts out of the end cap in hope of cutting the can down but the cap just wount budge i tryd prying it a lil but no luck any sugestions on how to solve this thanks anthony

 

Hmmm..looks like you'd need to hit the end tips or something to get it down. You going to be doing 12's or something? If not it doesn't look like those tips stick out that much from the tail.

 

if your just learning id say leave it
i used my old hindle as a bar for a long time and its more forgiving
if not...i dunno
i bought a 2 inch shorter can for mine so it doesn't stick out at all

 

scrape exhaust...

 

Yup haha I'd say just go back stock exhaust or something. It's quieter and on top of that has smoother low end. Plus it's like a OEM round bar in the back.

 

those caps are gorrila glued ...it take a act of god to get them off... you need a gangster as heat gun... or go the route i did ...go by some epoxy that can withstand heat... and cut the exhaust from the rear... pop out the rivets and re rivet the exhaust back in place and use the epoxy for extra grip.... i got some epoxy from a auto zone.. that once it sets it will not break done until like 490 degrees... but it cost like 20 bones.... hope that helps... i would post pics... but i sold my rr a year ago

 

Holy **** those are tough. I had one too.

Its BOZ, as in BEN AND ERIC BOSTROM


Take a broomhandle and stick it inside to the other end and smash the broomhandle to the ground with the pipe in your hands.
Or if your gonna cut it, just cut it first and get the cap off once its already separated.

 

I would go back to stock and not ruin that nice exhaust