I just went though a change in bike. on my earlier bike, i had a 12 bar installed which i used to scrape the tail with ease. but on the new pulsar 220. i am facing problem. 2 out of 20 attemts of scrapping are sucess, rest fail... the tail is a bit inside.... help

Does it make much difference with sprocketing , as my earlier bike was 16+ and the new one is still stock (38 rear)??

 

You'll get used to it in time....

Sprockets shouldn't matter if you're coasting

 

u mean scraping*?

 

I dont know about where you live, but here in missouri you need a contractors license to scrap large amounts of metal.

It usually works best if you have a friend who is a contractor

 

Coasting to a scrape


I never scraped on purpose!!!!

My 12 bar is more of a Catapult !

 

oh i have no problems coasting, but the tails scrape is lot behind the coaster, i even pull her back more, but still no scrape.

 

just go till it scrapes use those kahoneys