....one fat **** at a time!!!!

 

+1000000
if i had a penny for every ziptie thats on my bike.... well i wouldn't have to have zipties on my bike.

 

What the squid!!??

 

jb weld and a cut up pepsi can on the stator cover.(buddies bike)

short somewhere from my selinoid to my start button so i started my bike with a screw driver for about 6 months then just hooked two wires and a switch up !!

 

"keepin it gutter like a stick of cheap butter"

 

if this means ghetto riging is the **** then :YEAH

 

busted a hole in my radiator, cut the fin with wire cutters and folded it back with needle nose pliers, didnt leak or get hot. still rockin that ****. acerbis is held on with zip ties and so is my battery tray, oh, and my taillight too.

 

why is your acrebis held on with zips?? didnt yours come with those straps or did you bust that **** too

 

its a knock off and it came with brackets that stuck out real far and looked like ***. so I zip tied it.

 

haha good **** man hey rigg that bitch so it works, thts all that matters!!:YEAH

 

updated my avitar, now you can see the zip tie magic in action.

 

this sucks typing because i went down tonight.. but anyways .
headlight ziptied on, windshield ziptied, right and left fairing ziptied, non fairing stay , no cluster , bent front wheel ,barely any brakes ,tailight ziptied, radiator 12 guage wire cause the zipties broke,leaky radiator has jb weld and quick steel , battery tray in 3 different pieces ziptied, tank has a helicopter o ring in it so it doesnt leak on stoppies,right peg bent , i dont feel like typing what else is wrong becaue i think my shoulders broke:YEAH

 

+1
them 1/4 inch zip ties are da bomb yo

 

daaaaaaaaammmmmmmmmmmmm

 

:YEAH :YEAH

 

i zip tie pretty much everything on my bike.. when my 929 left rear pass bracket broke i ziptied the one from the f4i lot bike on it just to do some stag whoolies.. it was strong as **** too but didnt wanna test my luck for too long

 

i have a bad problem with losin bolts. my passenger peg is held by zip ties on the exhaust side. and my tank and seat are both held on by one bolt. i mounted my tail light upside down so u can see it with the 12 bar and it is ziptied, after i put db bars on i had to re-route a bunch of cables and the tank seemed like it was tryin to cut my throttle cables. i rigged up a spacer to raise the tank a little. the bolt is from a bar end because it is the same thread and longer, and gor a spacer i used two nuts that were slightly larger than the bolt but it seems to work fine. btw i thought i was the zip tie king but i have been put badly to shame.

 

hahah i forgot i took my faring stay when it broke drilled 3 holes zip tied in and then jb welded around it all, works like a charm

 

I guess, I will develop some Zip-Ties with woven in Kevlar. That should be a good business idea, after I see how much people rely on them ;-)

 

DO IT!!!!!!! cuz i got some zipties from walmart tried to bend i a little to go around my frame and it broke just bending it like 45degres