I'm a noob at stunting and just picked up a 1998 CBR600F3 as a stunter. Any special tips besides a cage and 12 bar (Frame/ sub frame strengthening)?

 

NO.......youre good to go.....

 

I'ld take it to your local welder, and have that subframe beefed up...

 

yea get the subframe stregnthed besides that.... you should be fine honda's can take a beating

 

Those old F3's have beefy steel frames, the sub-frame is welded to the rest of the frame. I would think it would be fine.

 

have fun and tear it up..!!!!!!!!

 

sweet thanks

 

IMO i wouldnt get a 12bar to learn on ive seen them do more damage to people then help.

 

+1

 

what has the 12 bar done to people?

 

get a sickinnovations round bar

 

If you cant scrap Very well you can look forward to corners catching on the 12 bar and your bike spinning. If you dont hit them just right they dig into the cement especially blacktop nice and good. They are by no means a safety precaution like alot of people seem to think. Round bars on the other hand are nice and keep your tail section from going crunch crunch like mine!!!

 

um flat bars will **** you up.


a guy i ride with jumped of the back and it caught him in the ****** rectum. (no joke)

rip his **** like ribbon wire since intestine is smooth muscle. that was in september. he had emergency surgery. had a calostomy bag (**** out a hole in your stomach into a bag)

i was over there today and he just had his final operation last week.


o yah... and they can pound you pretty well when you flip a stoppie.

 

this is what can happen when your 12 bar makes contact with your body.

 

but doesnt a round bar eventually become scraped enough to where it becomes razor sharp ?

 

o **** man...is that you???

 

+1 that's a nasty *** cut!

 

yup, that is me, happened the day before halloween, 22 staples and 16 stitches.plus a broke wrist and ripped my chin amost complely off.









sorry for stealin this thread.

 

Holy sh itt! You got messed up. Did you have a helmet on?