i'm aboutto go outside and check it out this morning and uodate yall, when we found the liek iy was already dark and we didn't have that much light, just had to feel for the liek. i might just pop the plastic piece out and check the O-ring if i don't see any external damage.

 

man all that and you dont realy know if thats where its comming from ......dgfoiugiuwhgpoiayecaeor yae thats right your a oiwegoiweugpoif

 

i was thinking that in the back of my head but then again is using a yamaha front master for a hand brake common enough to know if they leak upside down? if somebody using a r6 front master for a handbrake could chim in it would seal the deal.

 

FFFAAAWWWWK ! i went outside, looked under, pulled the lever a few times and even in the light it looked like it came straight out of where the plastic connector and the master meets. Well i thought, the only other place it might be come-n from is the banjo bolt and brake line you know maybe it's not tight somehow. so i had to lossen the master up slide it down the bar and well well well there is a trail of brake fluid come-n from the bolt/line. So sombody who hooked up the line who i will leave nameless (SYTFU_R6) didn't tight-n it enough when they were putting the brake line on. so i tightened it more and guess what??? NO LEAK

Sorry for the huge waste of time everybody, yall always come threw though in MY defense it did get dark right when we were done and we didn't have a flashlight or anything to see under there and I thought the line was tight so.... hey what can i say lol.

 

bwuahahhaha, I didn't wanna strip it.... but oh well, trial and error for two ****** that know nothing bout nothin... lmao. all we wasted was brake fluid, not skin so its all good.

but in my defense, beside the light issue... I swear I had that ***** tight, but oh well... got'er done now. my punk *** is on a train, but when I get back the weather will be cleared up, and I know what I will be doin!

 

you son of a hvhdaoihjsafoewygjfoiehvouvjkeoieuovh

 

 

ps i have an 03 r6 master for a hand brake its awsome but i also put a 600 rr front caliper on the rear so i think almost any master would work for me

 

what's the torque number for the banjo bolt?! on a 10000RR master? and how many crush washers, just one on each side of the fitting, right?

 

stay away from the wrench stfuy_6r6r