so i got my dual caliper set up almost done all i need is the steel brake line. and my ? is when i order the line does 1 end hafta have a fitting for a 954 master cylinder and 1 end have a fitting for an f4i rear caliper?

 

No. Both ends should use a banjo bolt, however... there are two types of banjo bolts. Single shot and double shot (probably not the technical term), but you need a single shot since only 1 line will be comming off the brake. The rear will always be a single.

 

k sweet.....

 

****! will a bolt for a rear or caliper fit on a front master? (929)

 

Take it apart and see.. you're gonna have to anyways to install the new line.

I used a banjo from a GSX-R 1000 ('04) on a master from a '03 R6, to connect to my Speigler line from Full Throttle. Most of the hardward is universal.

 

ya, there are two different threads or bolts, fine and coarse, and two different lengths, it will be one of the four..