well since i rattle can'd my 50 yellow and sherman said it fades to brown after a while ill probably decide to just powder coat that **** when it fades...

the question i have is if i "powder coat" it in yellow again is it going todo the same thing .. cause i want to rock yellow bad but if the sun is going to rape me then ill have to try and come up with another bright color idea.. and also do all bright colors do this in the sun i mean 3 weeks damn .... ex: white , yellow, lime green u get the idea

 

check out these colors!

 

hahahah what the hell happened there did u let a little kid go at it with a spray paint can or what

 

Nothing happens to powdercoat...its virtually indestructable.....

The only thing about powdercoat though is that you need to sand the frame back down to bare metal so it will stick the best.

 

well the place im going to take it to will sand blast it 1st i just wanted to make sure if i got pc'd yellow that it wouldnt do the same and fade

 

Powder coating will be resistant to UV rays (the sun) and many chemicals. It is nearlly bullet proof, the powder is electrically bonded and baked to the metal surface. In the event of mass carnage to your fiddy, the powder will continue to adhear to bent and tweaked metal as long as it isn't a sharp break clean through.

 

i mean come on greg...even i could told ur *** that. and i cant even open the fkin box...still...and i knew what the combo would be without opening box duuuuh 1994. sometimes im amazed that u have that bad *** job

 

so will a good base coat clear coat if done properly
krylon turned brown cause he put to many coats of clear on it
also another mistake was blasting the frame
if your just gonna paint it dont blast the frame
use a white scotch brite with sand fix and scrub it
any scratches need to be sanded and primed
but i would never take off the honda finish they have multi million dollar facilities to keep it perfectly clean and no moister on the frame
raw steel will rust almost instantly from the moister in the air you put your finger on it come back an hour later and youll see a rusty fingerprint
but if your gonna powder coat then you have to blast
this frame was frenched from the 60's so i had to remove all the
bondo check and re weld up bad welds then re bondo and paint

 

I had sandblasted my frame, primed it white about 7-8 coats, painted it yellow about 8-10 coats, 3 coats of clear.......it looked pimp for less than three weeks.....turned **** dark yellow!!! OH WELLL.......she is at the powder coater now....no more yellow frame for me........but hey who cares, its like a model car....taking it apart and putting it back is fun as hell!!!!! good luck to all the rattle canners out there.......im drunk and going to bed.......


word.........

 

no sealer?
time between coats?
to many mills thick you get ready to paint again come over ill show ya some tricks

 

lots of time between coats trust me.......rattle can agian HELL NO!

I rather spend the money now......f-that spray paint.....lol sorry two thumbs down on it.................powder coat is the only way to fly, i learned the hard way......oh well hell its just a fiddy................lol its all about riding anyway.......

 

otay whatever yasay

im dont do rattle can either
base coat clear coat
the pic of the uncle sam is one of my tanks
if i dont sell it b4 the fiddy chopper gets done itll be on it
heheheheheh